Repeat until you have the required number of warps on the loom. Go around the screw and return, using the slot next to the one used first. Holding the warp thread taut, but without stretching it, go over and between two corresponding center coils of the spacing spring at the other end of the loom. Starting at approximately the center of the loom, string the warp thread over and between two coils of the spacing spring. Using a simple overhand loop knot, tie off the warp thread to the screw at one end of the loom. If the project ends in a one- bead point, there must be an even number of warp threads to accommodate an odd number of beads. You will always need one more warp thread than the number of beads wide the project is-one bead is placed between each pair of warp threads. Then we'll get to the nitty-gritty of designing and planning a project and having some fun. It is also important to change your eye focus periodically by stopping and looking at something far away and letting your eyes refocus to normal. Do not try to work for long periods without a break.
If you are experiencing back pain or muscle strain while working, you need to change something. A comfortable and supportive chair and a table of the right height are essential. It is important to have comfortable working conditions. In this article I'll give you the basic techniques of warping, weaving, and finishing.
0 kommentar(er)
